Non-Hot-Plug Pci Riser Board Slot Definitions - HP ProLiant DL360 Gen9 User Manual

Item Description

Non-hot-plug PCI riser board slot definitions

•
Primary riser cage connector, connected to processor 1 or the southbridge
1 - 3/4L/FH
2 - LP
3 - LP/3/4L/FH
*The server ships with one PCIe3 riser cage installed in the primary riser cage connector.
**The x16 PCIe3 riser cage is optional and can be converted to a FH riser. This conversion requires a
second processor to be installed.
Notes:
•
"Primary" denotes the riser cage is installed in the primary riser connector.
•
"Secondary" denotes the riser cage is installed in the secondary riser connector.
•
Installing the riser cages listed in the table above in either the primary or secondary riser connectors
determines the form factor of the PCI cards supported by those riser cages.
•
FL/FH denotes full-length, full-height. HL/FH denotes half-length, full-height. LP denotes low profile.
Status
•
Power supply failed
•
Power supply in standby mode
•
Power supply exceeded current limit
PCIe 3-slot riser cage*
PCIe3 x8 (8,4,2,1)
PCIe3 x8 (8,4,2,1)
PCIe3 x16 (16, 8,4,2,1)**
PCIe 2-slot x16 riser cage
PCIe3 x16 (16,8,4,2,1)
PCIe3* x8 (8,4,2,1)
—
Component identification 14