Table of Contents
Advertisement
Viewing images on a television
It is possible to view camera images on your television. The camera has a video-out terminal to
make the connection using the supplied Video cable VC-400. The camera is compatible with the
NTSC and PAL standards. The video-output setting can be checked and set in section 4 of the
setup menu (p. 96). To view images recorded in the internal memory, remove the memory card from
the camera.
1. Turn off the television and the camera.
2. Insert the small plug of the video cable into the camera's
video-out terminal. The arrow mark on the plug should face
the back of the camera.
3. Plug the other end of the video cable into the video input
terminal on the television.
4. Turn the television on.
2
5. Change the television to the video channel.
6. Turn the camera's mode dial to the playback position and
turn on the camera. The camera's monitors will not activate
when the camera is attached to a television. The playback-
mode display will be visible on the television screen.
7. View images as described in the playback section.
84
A
DVANCED PLAYBACK
SETUP MENU
The setup menu is used to control the camera's functions and operation. The navigating the setup
menu section covers the operation of the menu. The section is followed by detailed descriptions of
the settings.
Opening the setup menu
The setup menu is opened from the other menus. It can be accessed from any of the recording or
playback menus.
Drive m
Image
Drive mode
Single
Quality
Image size
2560x1920
Auto D
Quality
Standard
Digital
Auto DSP
On
Digital zoom
Off
LCDbrightness
–
Power save
1 min.
Inst.Playback
Off
Lens acc.
None
Language
English
Setup menu
Use the right key of the controller to highlight setup
tab at the top of the menu.
Press the central button of the controller to open the
setup menu.
Reverse the procedure to return to the original
menu. Pressing the menu button closes the menu
and returns to the recording or playback modes.
85
Advertisement
Table of Contents
