Table of Contents
Advertisement
9. Error and information messages
HEAt
This message appears if you try to switch on the lamp within 5 minutes after having switched it off (the
lamp is too hot). The message will appear on the display if the lamp doesn't ignite within 28 seconds. The VISION
575 will store this information and automatically ignite the lamp when the 5 minutes period has expired.
LAEr
The ignition of the lamp is seven times unsuccessful (the HEAt message appeared six times before), and
the display shows " LAEr ", meaning that the lamp could be damaged or even missed, the fixture is overheating
(this can occur if the ambient temperature is 45° C or more) or there could be a failure on the ignitor or ballast.
Please place or replace the lamp, check the ambient temperature or contact your dealer if the situation was not
caused by the lamp.
FAn
The message informs you that the fixture was overheating and switched off. This message will appear on
the display if the fan speed operating "LOOF" was selected.
MbEr
This messsage informs you that the main PCB does not communicate correctly with the Control Board.
CoEr (color-wheel error)
This messsage will appear after the reset of the fixture if the magnetic-indexing circuit malfunctions (sensor
failed or magnet missing) or the stepping-motor is defective (or its driver circuit on the main PCB). The color-wheel
is not located in the default position after the reset.
SGEr (static gobo wheel error)
This messsage will appear after the reset of the fixture if the magnetic-indexing circuit malfunctions
(sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main PCB). The static
gobo wheel is not after the reset in the default position.
rGEr (rotating gobo wheel error)
This messsage will appear after the reset of the fixture if the magnetic-indexing circuit malfunctions
(sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main PCB). The rotating
gobo wheel is not after the reset in the default position.
IGEr (rotating gobo indexing error)
This messsage will appear after the reset of the fixture if the magnetic-indexing circuit malfunctions
(sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main PCB). The rotating
gobo is not after the reset in the default position.
EFEr (effect wheel error)
This messsage will appear after the reset of the fixture if the magnetic-indexing circuit malfunctions
(sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main PCB). The effect
wheel is not after the reset in the default position.
FtEr
This error message informs you that the fixture was overheating (occured if the ambient temperature is 45°
C or more) and that the relay switched off the lamp. This message will appear on the display until the temperature
will be on a suitable level, then the display will show the " HEAt " message meaning the lamp is too hot (explanation
see above).
SnEr
This message appears if the lamp lighting sensor is failed.
PoEr
This message will appear if the fixture was shortly disconnect from the main.
FrEr
It will appear if the frequency of the main is not standard 50 or 60Hz.
19
Advertisement
Table of Contents
