Error Diaplay - Canon i350 Simplified Manual

3. ERROR DIAPLAY

Errors are displayed by the LEDs, and ink low warnings are displayed by the status monitor.
3-1. Operator Call Error (Orange LED blinking)
LED Display
Blinking 2 times Paper out
Blinking 3 times Paper jam
Blinking 4 times Ink tank not installed
Blinking 5 times Print head not installed or failure has
occurred in the print head.
(Not-supported print head (see page 5) is
installed or print head EEPROM data is
abnormal.)
Blinking 8 times Waste ink full or platen waste ink full warning
(Approx. 95% of acceptable amount)
3-2. Service Call Error (Orange and green LEDs blink alternately)
LED Display
Blinking 2 times Carriage error
Blinking 6 times Internal temperature abnormal error
Blinking 7 times Waste ink full or platen waste ink full error
Blinking 8 times Abnormal temperature rise
Blinking 9 times EEPROM error
Blinking 10 times No cartridge detected excepting print head
replacement (during printing)
3-3. Ink Low Warning (Ink low warnings are displayed by the status monitor only when the remaining
ink level detection is on, and no status monitor display when off.)
Content
Ink low warning 1 (approx. half level)
Ink low warning 2 (low remaining ink)
Ink low warning 3 (ink level unknown)
Content
Content
5
Corrective Action
Set paper, and press the RESUME
button to feed the paper.
Remove the jammed paper, and press
the RESUME button.
Re-install the ink tank, and close the
access cover.
Re-install the print head, and close the
access cover. Or confirm the print
head is "QY6-0044-000" and perform
re-installation. If not recovered with the
cartridge installed, power the printer off
and on.
Recoverable by pressing the RESUME
button.
Corrective Action
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.
Replace the printer as it has failed.
Display by status monitor