Wolf E Series Installation Instructions Manual page 9

C h i m n e y i s l a n d h o o d s i n s t a l l a t i o n
F i l t e r i n g v e r s i o n
ATTENTION: Three people are required for
proper installation; the unit should be installed
by a qualified operator. Also follow carefully
each step of the assembly instructions, and
once installation has been completed, make
sure that the hood is firmly secured in place.
Prepare the power supply within the telescopic
flues (for the electrical connection, follow all
the other instructions on the "Warnings"
section).
Fix the telescopic structure to the bracket by
means of 4 screws (provided), running the
electric power cable through the special hole in
the bracket (Fig. 22).
Adjust the height of the telescopic structure by
means of the four retaining screws C (Fig. 23),
taking into account that the height of the hood
is 80 mm and that the distance between the
hood and the hob must be at least 650 mm
(Fig.24). Insert the air baffle (F) in the structure
(Fig.29).
Through the openings E (Fig.30), fit the flange
(G) to the baffle (F) locking it with a turning
movement.
Fix a flexible pipe to the flange (G) for air
evacuation (Fig. 30).
Take the upper flue (with the round slots) and
fit it on the telescopic structure with the slots
facing upwards; fit the flue to the bracket with
2 screws (Fig. 25).
Take the lower flue and fit it in the same manner
as before; slide it to the top and stop it in that
position using a adhesive tape (Fig. 26).
Take the reduction (Fig. 31L) and assemble it
onto the air venting opening of the hood,
pressing slightly.
Fit the hood to the telescopic structure by
means of 4 screws (provided) – Fig. 32.
Fix the air evacuation pipe onto the reduction
(L).
Make the electrical connection by means of the
power cable.
Remove the adhesive tape and pull the lower
flue downwards, placing it gently onto the
apparatus.
Fitting the charcoal filter: turn the panel gripping
it from the font part of the hood (Fig. 33).
Remove the grease filter: push the handle
outwards and pull the filter downwards; then
fit the charcoal filter (Fig.34) by inserting the
two filter clips in the slots and turning the filter
towards the inside of the hood.
Installation is now complete and the grease
filters can be reassembled.
fig. 29
fig. 30
fig. 31
fig. 32
EN
fig. 33
fig. 34
9