Wolf E Series Installation Instructions Manual page 7

C h i m n e y w a l l h o o d s i n s t a l l a t i o n
V e r s i o n w i t h a n e x t e r n a l m o t o r
ATTENTION: Two persons are required for
proper installation; the unit should be installed
by a qualified operator.
Before fixing the hood the air evacuation pipe
running from the hood to the external motor
should be ready.
Use an outlet pipe with:
– minimum indispensable length;
– minimum possible bends (maximum angle
of bend: 90°);
– certified material (according to the State);
– an as smooth as possible inside. It is also
advisable to avoid any drastic changes in pipe
cross-section (recommended diameter: 150
mm).
For air evacuation to the outside, follow all
the other instructions given on the "Warnings"
section.
Prepare the power supply within the telescopic
chimney (for the electrical connection, follow
all the other instructions on the "Warnings"
section).
Fixing to the wall
Draw a line on the wall in vertical line with
your hob. Mark the first 2 holes to be drilled
in the wall, respecting the distances indicated
in Fig. 4. Drill the 2 holes and fit the screw
anchors provided.
Bear in mind that the distance between the
lower edge of the hood and the hob must be
min. 650 mm.
Fix the metal bracket (A) to the wall using
the 2 holes just drilled (Fig. 4); the screws for
fixing the bracket are provided. Use the 2
cut-out triangles on the bracket to position it
exactly along the vertical axis of the hood.
Hang the hood on the bracket (Fig. 6).
Adjust the horizontal position moving the hood
to the right or left so that it is aligned with the
wall units. When adjustment has been
completed, without removing the hood, mark
the other 4 holes to be drilled (C) in the wall.
Remove the hood and drill the holes marked
(8 mm diameter). Then use the 4 screw
anchors and the 4 screws provided for final
fixing.
Mount the plate of the electrical system fixing
it with 3 screws (Fig. 18).
Fixing the telescopic flues
Adjust the width of the support bracket (D) of
the telescopic flue by means of the screws
(E) as shown in Fig.9; then, by means of the
screw anchors and screws (F) provided, fix
the bracket to the ceiling in such a way that
it is positioned along the axis with your hood.
Connect the air outlet pipe to the air vent of
the hood.
Use a flexible pipe and lock it to the air vent
of the hood with a metal hose clamp - Fig.
10 (pipe and clamp are not provided).
Turn the upper flue over so that the air
exhaust grid is in the lower section (Fig. 11).
Connect the hood to the external motor using
the special terminal block (Fig. 19): remove
wire clamp A and lid B from the wiring junction
box; fix the connecting wire of the external
motor to terminal C; then replace wire clamp A
and lid B on the wiring junction box; the other
end of the wire is secured to the terminal block
on the external motor.
Plug in the hood.
Insert the extension flues setting them on the
hood; extend the upper flue to the ceiling
and secure with the 2 screws (H) - Fig. 12.
fig. 18
C
A
B
EN
fig. 19
7