Changing Tools; Operation - Kompernass KH 1410 Operating Instructions Manual

Changing tools

When you want to change the tool, proceed as
follows:
1. Select the desired tool:
Floor tool e :
Crevice tool :
f
Upholstery brush : To vacuum dust from up-
g
2. Switch the machine off at the On/Off switch
Attention!
Remove the plug 9 from the wall socket. The
appliance could be inadvertantly switched on.
3. Remove the fitted tool from the telescopic
tube o .
4. Place the desired tool on the lower end of the
telescopic tube o
5. Store the no longer required tools as far as
practicable in the accessory bracket

Operation

Attention!
Before every utilisation check to ensure that all filters
are correctly inserted and that no openings are
blocked. The filters must show no sign of damage
and must be dry. If not, there is a risk of overheating!
The appliance could be irreparably damaged.
1. Fit the required tool (see chapter „Changing
tools").
2. Pull the power cable
up to the yellow marking.
To vacuum carpets or hard
floors.
To vacuum dust from
difficult to reach locations.
holstery or other fabric
surfaces.
.
p .
9 from the cable storage
Attention!
Should the red marking on the power cable
visible, rewind the power cable
the foot button for power cable rewind
the yellow marking. Otherwise, the power cable
could break off.
3. Press the On/Off switch
4. Adjust the suction power with the suction
power regulator
5. If you are using the floor tool
ting for carpet/hard floor
switch:
• Press the carpet/hard floor selector
switch
surfaces such as laminates, tiles and
5 . PVC etc.
• Press the carpet/hard floor selector
switch
surfaces, such as long or short pile
carpets and rugs etc.
6. Pull the vacuum cleaner after you like a sledge.
When vacuuming, pay heed to the information
providet by the floor covering manufacturer.
Notice:
Should you need to reduce the suction power, e. g.
if a curtain is sucked in, open the secondary air re-
gulator s .
7. Press the On/Off switch
um cleaner off.
8. Remove the power plug
ket.
9. Hold the power plug
foot button for power cable rewind
the power cable
- 4 -
9 , by pressing on
5 .
7 .
e , adjust the set-
w with the selector
w to the rear for hard floor
w to the front for carpeted
5 to switch the vacu-
9 from the wall sok-
9 firmly and press on the
9 to pull itself in slowly.
9 be
8 , back to
9
8 . Allow