Advertisement
17
IMMOBILIZER INTERFACE PROGRAMMING
NOTE: IF YOU DID NOT START THE CAR WITH THE IGNITION KEY AS INSTRUCTED TO IN SECTION 15 STEP 5
THEN THE VEHICLE WILL NOT ATTEMPT TO START, INSTEAD YOU WILL GET THREE ADDITIONAL BEEPS FROM
THE HORN. THE VEHICLE HAS TO BE STARTED AT LEAST ONCE WITH THE KEY FOR THE REMOTE ENGINE
START FUNCTION TO OPERATE.
1. Transponder interface programming:
NOTE: Two programmed ignition keys are required for this step and hood must be closed.
a. Sitting in the driver seat, be prepared to press the brake pedal to shut down the remote starter
system.
b. Using the first key, turn the ignition on, wait for the THEFT light to turn off, then turn the ignition off and
remove key from the ignition switch.
c. Using the second key within 5 seconds, turn the ignition on, wait for the THEFT light to turn off, then
turn the ignition off and remove key from the ignition switch.
d. Activate the remote start function by pressing the LOCK button followed by the START button within
5 seconds.
The system should flash the parking lights and chirp the horn one time, pause for four seconds then
start the engine.
e. After the engine is started. Press the brake pedal to shutdown the engine. The Immobilizer interface is
now programmed.
f. Attach new Remote Engine Start transmitters to keys and place original factory transmitters in glove
box.
18
FUNCTION TEST
All Door Lock / Driver's Door Unlock / All Door Unlock
1. Press the LOCK button once - All doors should lock and the parking lights should flash twice.
2. Press the LOCK button again (within five seconds) - All doors should remain locked, parking lights should flash
twice and the horn should beep twice.
3. Press the UNLOCK button once - Driver's door should unlock, parking lights should flash once and interior lights
should turn on.
4. Press UNLOCK button again (within five seconds) - All doors should unlock, parking lights should flash again,
interior lights should turn on.
Panic button (with Real Panic Sound®)
1. Press and hold the PANIC BUTTON for one second - Horn should start sounding intermittently (Real Panic
Sound®) and parking lights should flash.
2. Press and hold PANIC BUTTON again for one second - Horn should stop and parking lights should stop.
14
1031012 Rev.A 09/05
Advertisement
