Advertisement
9
IMMOBILIZER INTERFACE RIBBON CABLE MOUNTING
1. Route the immobilizer interface (previously installed) ribbon cable
to the ignition switch, making sure to keep it away from any moving
parts.
2. Following the instructions on the supplied ampule of adhesive primer,
apply a thin coating to the entire transceiver antenna ring (black plastic
ring around key switch, FIGURE II) and to the ribbon cable.
3. Remove the backing from one side of the supplied 2-way tape and apply
tape around the transceiver antenna ring (black plastic ring around key
switch, FIGURE JJ) keeping the tape off of the roundedpart of the igni-
tion switch face and trimming excess 2-way tape if necessary.
4. Remove the remaining backing on the 2-way tape and position the ribbon
cable around the transceiver antenna ring, with the striped side facing
the ignition key opening. (FIGURE KK)
5. Using a supplied tie wrap, secure the antenna coil. (FIGURE KK)
9
FIGURE II
FIGURE JJ
FIGURE KK
1031012 Rev.A 09/05
Advertisement
