Sensor (Fuser Exit) Off Jam - Lexmark W840 Service Manual

Step
6 Check the registration clutch connection.
Is the registration clutch properly connected?
7 Perform a print test.
Does the error continue?

202.00 Sensor (fuser exit) off jam

Step
1 Check the media position.
Open the printer left door assembly and visually check it.
Does the media touch the sensor (fuser exit)?
2 Check the roll
Open the printer left door assembly and check it.
Is the transport roll assembly free of excess wear and
contamination?
3 Check the sensor (fuser exit) for proper operation.
1. Enter Diagnostics mode.
2. Select BASE SENSOR TESTS.
3. Select Media path.
4. Select Fuser exit.
Open the printer left door assembly and check it.
The area around the actuator is very hot. Allow the fuser
area to cool before proceeding.
Does the display, on the operator panel, change every time
the sensor actuator is operated?
4 Check the sensor (fuser exit) connection.
Is the sensor (fuser exit) properly connected?
5 Perform a print test.
Does the error continue?
Check
Check
Yes
Replace the Replace the
registration clutch. connection.
Go to
"Registration
clutch assembly
removal" on
page 4-78.
Replace the Problem solved.
printer engine card
assembly.
Go to "Printer
engine card
assembly
removal" on
page 4-120
Yes
Remove the media Go to step 2.
Go to step 3. Clean or replace
the transport roll
assembly.
Go to step 5. Go to step
Replace the Replace the
sensor (fuser exit). connection.
Go to "Sensor
(fuser exit)
removal" on
page 4-104.
Replace the Problem solved.
printer engine card
assembly.
Diagnostic information
4024-XXX
No
No
2-25