Maintenance - Husky HS518102 Use & Care Manual

Maintenance

GENERAL MAINTENACE
All repairs should be performed by an authorized service representative.
WARNING: Disconnect, tag, and lock out the power
source, and then release all pressure from the system
before attempting to install, service, relocate, or perform
any maintenance.
1
Checking and changing the oil
Maintain the proper oil level by checking the oil sight glass (1)
daily. Change the oil in the pump every 3 months. Use the following
procedure to change (or add) oil.
□ Run the compressor for ten minutes to warm up the oil if the
unit has not been in use for an extended period of time.
□ Turn the compressor off and disconnect the compressor
from the power source.
□ Position a pan under the pump drain plug (2) to catch the oil.
□ Remove the pump drain plug (2) and allow the oil to collect
in the pan.
□ Reinsert the oil drain plug. Remove the oil fi ll plug (3). Pour
new, unused oil into the pump. Do not overfi ll.
□ Reinsert the oil fi ll plug (3) into position. Return power to the
compressor for use.
2
Checking the ASME safety valve
□ Run the air compressor until it reaches cut-out pressure.
□ Disconnect the compressor from the power source.
□ Put on safety glasses. Protect yourself from fast moving air.
□ Pull on the ring of the ASME safety valve (1). This
releases pressure from the tank. The safety valve should
automatically close at approximately 40 - 50 psi.
If the safety valve does not allow air to be released when you
pull on the ring, or if it does not close automatically, it MUST be
replaced.
3
3
□ Disconnect the air compressor unit (A) from the power
□ Release the pressure from the compressor by pulling on
□ Open the drain valve (1) underneath the tank. Remaining
1
19
1
2
Draining the tank of moisture
source.
the ASME safety valve. The ASME safety valve should close
at approximately 40 - 50 psi.
air pressure will assist in removing moisture from the tank.
1
Please contact 1-888-43-HUSKY for further assistance.
HUSKYTOOLS.COM