Fork Position Adjustment - Husqvarna CR 65 2012 Workshop Manual

2
1
A
D
B
A
C
B: silencer retaining screw axle
C: rear wheel axle height
Workshop Manual Ed. 09-2011
SETTINGS AND ADJUSTMENTS
CR 65 2012

Fork position adjustment

- Loosen the two screws (1) onto bottom yoke.
- Loosen the steering head screw (2).
- Adjust one fork leg at a time.
Refer to the notches on the leg upper part to adjust the fork position according
to the rider height and the riding needs.
Align the steering head upper part with one of the four notches (A, B, C and D)
as shown in the figure.
To keep the desired position tighten first the screw (2) and then the screws (1)
fully home.
Repeat the operation on the other leg.
Carry out the same fork position adjustment procedure on both legs.
B
C
Shock absorber adjustment
The rear shock absorber must be adjusted according to the rider weight and the
road conditions. IT is possible to adjust the shock absorber acting on the spring
pre-load according to the rider weight.
The shock absorber adjustment affects both the stability and the
handling of the motorcycle. After changing the standard suspension
setting, ride with care. Before making any change, we recommend
to identify a reference dimension"A" with bike on the central stand
and front wheel raised off the ground.
- Have the bike resting on ground without rider.
Measure dimension "A".
The difference between dimension "A" with the wheel raised off the ground
and dimension "A" with the wheel on the ground shall be 25÷30 mm (0.98 ÷
1.18 in).
- Have bike resting on the ground with rider sitting on it;
Measure dimension "A";
The difference between dimension "A" with the wheel raised off the ground
and rider sitting on it shall be 60÷70 mm (2.36 ÷ 2.76 in).
D.16