Husqvarna CR 65 2012 Workshop Manual page 22

CHASSIS
Trouble
The handlebar is hard to turn
The handlebar vibrates
Shock absorption is
too hard
Shock absorption is
too soft
Wheel (front and
rear) vibrates
Rear suspension is
noisy
Insufficient braking
(front and rear)
Workshop Manual Ed. 09-2011
TROUBLESHOOTING
CR 65 2012
Cause
1. Tyre pressure insufficient
2. Bearing adjuster ring nut or steering stem nut overtightened Adjust
3. Bent steering stem
4. Worn or seized steering bearings
1. Bent fork legs
2. Bent front wheel axle
3. Bent/broken chassis
4. Bent front wheel rim
5. Worn front wheel bearings
1. Exceeding oil quantity in fork legs
2. Fork oil viscosity too high
3. Overinflated tyres
4. Improperly set rear shock absorber
1. Insufficient oil quantity in fork legs
2. Fork oil viscosity too low
3. Weak fork springs
4. Weak rear shock absorber spring
5. Improperly set rear shock absorber
1. Bent wheel rim
2. Worn wheel hub bearings
3. Incorrect spoke tension
4. Wheel axle nut loose
5. Worn rear swinging arm bearings
6. Improperly adjusted chain tensioners
7. Improperly balanced wheel
1. Shock absorber worn ball joints
2. Faulty shock absorber
1. Air presence in braking system circuit
2. Insufficient fluid in tank
3. Worn brake pad and/or disc
4. Damaged disc
5. Improperly adjusted brake pedal
6. Water in brake system
C.4
Remedy
Inflate
Replace bottom yoke
Replace
Replace
Replace
Replace
Replace
Replace
Drain the exceeding oil
Change
Deflate
Adjust
Top up
Change
Replace
Replace
Adjust
Replace
Replace
Adjust
Tighten
Replace
Adjust
Balance
Replace
Replace
Bleed
Top up
Replace
Replace
Adjust
Change fluid