Tmb-S Trolling Motor Bracket Installation; The Tmb-S Bracket Is Designed For One-Piece Bracket Transducers Only. - Lowrance HDS-5 Installation Instructions Manual

TMB-S trolling motor bracket installation

The TMB-S bracket is designed for one-piece bracket transducers only.

The TMB-S trolling motor bracket (Part No. 51-45) is an optional accessory and is
available through LEI Extras at www.lei-extras.com. The TMB-S bracket is used
to attach a one-piece bracket transducer to a trolling motor. If you regularly fish in
water with a lot of underwater structure, such as rocks, stumps and trees, you may
consider using a Pod transducer for trolling motor installation. Pod transducers can-
not be "kicked up" by underwater structure.
Bolt
Using the components supplied with the TMB-S bracket (adjustable strap, in-
ternal tooth washer and plastic bracket) attach it to the transducer as shown
Slide the adjustable strap through the plastic bracket as shown above, left,
then slip the strap around the trolling motor as shown in the image, at right.
Position the transducer so its "face" is pointing straight down when the troll-
ing motor is in the water. Tighten the adjustable strap securely to the trolling
motor. Make sure there is enough slack in the transducer cable for the trolling
Internal tooth washer
Plastic bracket
Flat washer
in the diagram above.
Adjustable strap
motor to turn freely.
Lock nut
Route the transducer ca-
ble along the trolling mo-
tor shaft. Use plastic ties
(not included) to secure
9
the cable to the shaft.