Assembling The Transducer Bracket; One-Piece Bracket Assembly; Two-Piece Bracket Assembly - Lowrance HDS-5 Installation Instructions Manual

3. Assembling the Transducer bracket

After determining the correct position for the ratchets, loosely assemble the trans-
ducer and bracket assembly as shown in one of the two diagrams below.

One-piece bracket assembly:

Lock nut
Rubber washers
Ratchets
Do not tighten the transducer bracket assembly until you have aligned the

Two-piece bracket assembly:

Bolt
Small flat washer
Do not tighten the transducer bracket assembly until you have aligned the
Metal washer
transducer and bracket on the transom.
transducer and bracket on the transom.
Ratchets
5
Metal washer
Bolt
Large flat
washer
Lock nut
Thick rubber washer