Wireless Remote Commander - Sony nxcam HXR-NX3D1E Operating Manual

Wireless Remote Commander

Remove the insulation sheet before using
the Wireless Remote Commander.

DATA CODE button (81)

TC RESET button (42)

SCAN/SLOW buttons (30)

/ (Previous/Next) buttons (30)
 

PLAY button

STOP button

DISPLAY button (25)

Transmitter

START/STOP button (24)

Power zoom buttons

PAUSE button

MODE button (28)
Displays an Index screen during playback.
GB
11
Insulation sheet

/ / / /ENTER buttons
   
When you press any of these buttons, the light
blue frame appears on the LCD screen. Select
a desired button or an item with
then press ENTER to enter.

Notes
Aim the Wireless Remote Commander towards

the remote sensor to operate your camcorder
(p. 114).
Point the remote sensor away from strong light

sources such as direct sunlight or overhead
lighting. Otherwise, the Wireless Remote
Commander may not function properly.
When you are operating with the Wireless

Remote Commander supplied with your
camcorder, your video device may also operate.
In that case, select a commander mode other
than DVD2 for your video device, or cover the
sensor of your video device with black paper.
To change the battery of the Wireless
Remote Commander
 While pressing on the tab, inset your fingernail
into the slit to pull out the battery case.

Place a new battery with the + side facing up.

Insert the battery case back into the Wireless
Remote Commander until it clicks.
Tab
WARNING
Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.
When the lithium battery becomes weak, the

operating distance of the Wireless Remote
Commander may shorten, or the Wireless
Remote Commander may not function
properly. In this case, replace the battery with
a Sony CR2025 lithium battery. Use of another
battery may present a risk of fire or explosion.
/ / / ,
   