S Repacking Information - Epson PP 408 User Manual

Mount the Cutter and the Top Cover (only for the printer with cutter) as
Note:
described in the enclosed Packing Note.
Do not connect to the mains until the mains voltage selection has been
checked and the PM is installed.
Repacking Information
Save all packing material and boxes for future transportation of the printer.
To ensure maximum protection when transporting the printer, please pay
attention to the following:
1. Push the output stacker into the top cover and remove the power cord.
2. Remove the ribbon cassette.
3. Pack the complete printer in its original packing box and ship it.
Pay attention to the 'Packing Note'!
Getting Started Getting Started
1.2 Installing the Personality Module
The printer functions only in combination with an installed interface module,
called a Personality Module (PM).
The illustration below shows the standard PM with a serial and parallel interface.
For detailed information about your PM, see Chapter 2.
- To avoid damage due to electrostatic discharge, do not touch the pins
Note:
or components of the PM.
- Never attempt to install or remove a PM while the printer is switched
ON.
1. Remove the PM (16) from its packing material.
2. Insert the Personality Module (16) with the component side upwards until the
connector fully engages. Hand tighten the two lock screws (17).
1-3 1-4