This symbol (if applicable) on the product is used to identify the following important information: For equipment with internal power supplies: • Mains nominal AC voltage 110-120 V~ ; 50/60 Hz • Mains nominal AC voltage 220-240 V~ ; 50/60 Hz SMDR6 Regulations i...
Page 4
CLASS II POWER - VE SUPPLY 110 Vac 9 Vdc 0.6 A maximum CLASS 2 POWER - VE SUPPLY marking on the product indicates compliance with the EU Low Voltage Directive (LVD) and the Electromagnetic Compatibility Directive (EMCD). ii SMDR6 Regulations...
13. Do not use the telephone equipment to report a gas leak in the vicinity of the leak. 14. CAUTION : To eliminate the possibility of accidental damage to cords, plugs, jacks, and the tele- phone equipment, do not use sharp instruments during the assembly procedures. 15. Save these instructions . SMDR6 Regulations iii...
Class A and Class B when connected to host equipment that meets Class B. Do not attempt to repair this equipment. If you experience trouble, call or write for warranty and repair information. Nortel (Northern Telecom) 30 Norelco Drive, Weston, Ontario, M9L 2X6 Canada For more information call 1-800-4NORTEL. iv SMDR6 Regulations...
Page 7
Refer to the regulatory requirements as detailed in the System Installation Guide. Do not attempt to repair this equipment. If you experience trouble, call or write for warranty and repair information. Nortel (Northern Telecom) 640 Massman Drive, Nashville, TN, 37210 For more information call 1-800-4NORTEL. SMDR6 Regulations v...
Page 8
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. vi SMDR6 Regulations...
Bridge Taps: Not allowed Loading Coils: Not allowed IMPORTANT : More than one SMDR6 can be installed per KSU. Electrical Power for the SMDR6 is provided by the 9 Vdc power adapter connected to an external power source. requirements SMDR6 Installation Guide 1...
Screwdriver Paper wall mount plate (provided) Mounting the unit The SMDR6 unit must be installed within 800 m (2,660 ft) of the KSU. To install the unit: When using .5mm wire (24 AWG), select a location within 800 m (2,660 ft) of the KSU.
Page 11
888385_01 Install.book Page 3 Wednesday, November 11, 1998 2:45 PM Attach the DB25 serial cable to the RS-232 port of the SMDR6 unit by tightening the thumb screws. Connect the SMDR6 unit’s line jack (next to the DB-25 connec- tor) using a line cord to any unused station port on the KSU.
XON, XOFF 1 start bit 1 stop bit Note : The printer used for SMDR6 can be any RS-232 serial compatible device such as a serial printer, PC with communication software or call accounting package with the capability to collect data from the serial port.
M7324 telephone to program the unit. Check that the KSU port is operating by plugging in a working Norstar telephone. If the port is not operating, plug the SMDR6 into another port. Wait 60 seconds after plugging the unit into a new port. It can take up to 60 seconds for the unit to become operational.