Bell Expressvu; Standard Digital - VuQube V20 Installation And Operating Instructions Manual

STEP 2: BELL EXPRESSVU ANTENNA CONFIGURATION
1. On the VuQube controller, press and release the
ON button. Wait for the status light to flash orange,
and then WAIT 4 MORE SECONDS.
2. Press and release the ON button 8 times.
The status light starts rapidly flashing green and red.
3. Press and hold the
The status light will turn orange for 1 second,
and then start flashing green or red.
4. Press OFF.
5. After you have successfully configured the antenna, you must configure
your receiver for mobile use. To configure your receiver,
GO TO PAGE 18 AND RUN THE CHECK SWITCH.
1. On the VuQube controller, press and release the
ON button. Wait for the status light to flash orange,
and then WAIT 4 MORE SECONDS.
2. Press and release the ON button 36 times.
The status light starts rapidly flashing green and red.
3. Press and hold the
The status light will turn orange for 1 second,
and then start flashing green or red.
4. Press OFF.
5. After you have successfully configured the antenna, you must configure
your receiver for mobile use. To configure your receiver,
GO TO PAGE 18 AND RUN THE CHECK SWITCH.
Page 16
Standard Digital (satellite 91)
button for 4 seconds.
HDTV (satellites 82, 91)
button for 4 seconds.