VuQube V20 Installation And Operating Instructions Manual page 15

STEP 2: DISH NETWORK ANTENNA CONFIGURATION
1. On the VuQube controller, press and release the
ON button. Wait for the status light to flash orange,
and then WAIT 4 MORE SECONDS.
2. Press and release the ON button 12 times.
The status light starts rapidly flashing green and red.
3. Press and hold the
The status light will turn orange for 1 second,
and then start flashing green or red.
4. Press OFF.
5. After you have successfully configured the antenna, you must configure
your receiver for mobile use. To configure your receiver,
GO TO PAGE 18 AND RUN THE CHECK SWITCH.
DISH 500 Eastern Arc (satellites 62, 72)
1. On the VuQube controller, press and release the
ON button. Wait for the status light to flash orange,
and then WAIT 4 MORE SECONDS.
2. Press and release the ON button 36 times.
The status light starts rapidly flashing green and red.
3. Press and hold the ON button for 4 seconds.
The status light will turn orange for 1 second,
and then start flashing green or red.
4. Press OFF.
5. After you have successfully configured the antenna, you must configure
your receiver for mobile use. To configure your receiver,
GO TO PAGE 18 AND RUN THE CHECK SWITCH.
DISH NETWORK ANTENNA CONFIGURATION-continued on next page
DISH 500 (satellites 110, 119)
button for 4 seconds.
Page 13