Loading Originals In The Document Processor; How To Load Originals - Utax 6555i User Manual

Operation on the Machine > Loading Originals

Loading Originals in the Document Processor

The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals are
scanned.
Originals Supported by the Document Processor
The document processor supports the following types of originals.
Detail
Weight
Sizes
No. of sheets
Originals Not Supported by the Document Processor
Do not use the document processor for the following types of originals.
• Soft originals such as vinyl sheets
• Transparencies such as OHP film
• Carbon paper
• Originals with very slippery surfaces
• Originals with adhesive tape or glue
• Wet originals
• Originals with correction fluid which is not dried
• Irregularly shaped (non-rectangular) originals
• Originals with cut-out sections
• Crumpled paper
• Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam.)
• Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases before
loading. Failure to do so may cause the originals to jam.)

How to Load Originals

IMPORTANT
• Before loading originals, be sure that there are no originals left on the original eject table. Originals left on
the original eject table may cause the new originals to jam.
• Do not make an impact on the document processor top cover, such as aligning the originals on the top
cover. It may cause an error in the document processor.
2
35 to 220 g/m (duplex: 50 to 220 g/m
Sizes smaller than B6-R are 50 to 105 g/m
Maximum A3 to Minimum A6-R
Maximum Ledger to Minimum Statement-R
2
Plain paper (80 g/m ), Colored paper, Recycled paper, High Quality:
175 sheets (Mixed size originals: 30 sheets)
2
Thick paper (157 g/m ): 89 sheets
2
Thick paper (120 g/m ): 116 sheets
Art paper: 1 sheet
Document Processor
2
)
2
(one-side/duplex)
5-3