Kodak i600 Series User Manual page 61

Operator Log Message
Multi-feed detected
Multi-feed detected
Multi-feed length detected
Multi-feed length detected
No paper in elevator tray
Page on demand complete
Parameter settings conflicting
Pod door closed
Pod door opened
Power on self-test completed
6-8
ID#
23 A multi-feed document condition has been detected and the
scanner was set to the Display only mode.
• Check the host monitor to see if there are any overlapped
documents that may need to be rescanned.
This condition may be caused by poor document separation.
• Replace the separation roller tires and pre-separation pad.
See Chapter 5, Maintenance for procedures.
334 A multi-feed has been detected, the transport has stopped and
the job has ended.
• Re-enable the scanner. Check the host monitor to see if there
are any overlapped documents that may need to be
rescanned.
This condition may be caused by poor document separation.
• Replace the separation roller tires and pre-separation pad.
See Chapter 5, Maintenance for procedures.
247 A document was measured which exceeded the configured
maximum allowable length in the Display only mode. This may
be due to a document overlap.
• Check the host monitor to see if there are any overlapped
documents that may need to be rescanned.
This condition may be caused by poor document separation.
• Replace the separation roller tires and pre-separation pad.
See Chapter 5, Maintenance for procedures.
248 A document was measured which exceeded the configured
maximum allowable length and the transport has stopped. This
may be due to a document overlap.
• Re-enable the scanner. Check the host monitor to see if there
are any overlapped documents that may need to be
rescanned.
This condition may be caused by poor document separation.
• Replace the separation roller tires and pre-separation pad.
See Chapter 5, Maintenance for procedures.
260 The scanner was started with an empty elevator tray.
• Place the documents you want to scan in the elevator tray and
try again.
337 Informational message. The scanner has completed scanning
the requested number of documents.
4 The image processing values sent by the host are invalid.
• Check the job settings for illegal combinations. Refer to the
Image Processing Guide for valid parameter values.
213 Informational message. The pod was closed.
212 Informational message. The pod is not closed completely.
20 Informational message. The scanner has completed its self-tests
after power-on.
Description/Action
A-61500 April 2007