Making Connections; Installing The Ieee-1394 Card In The Host Computer; Installing The Kodak Driver Software; Installing The Firewire Cable - Kodak i600 Series User Manual

Making connections

Installing the IEEE-1394
card in the host
computer
Installing the Kodak
Driver software
Installing the FireWire
cable
2-2
Follow the instructions for installing the IEEE-1394 (FireWire) card and
the Kodak driver software before you plug the scanner into the host
computer.
IMPORTANT: You must install the software on the host computer
before you connect the scanner.
Install the IEEE-1394 (FireWire) card according to the directions
supplied with the IEEE-1394 card.
IMPORTANT: Use proper precautions to avoid static when you install
the IEEE-1394 card in your computer. Make sure the
computer power cord is disconnected.
1. Insert the Kodak i600 Series Scanners installation CD in the CD-
ROM drive. The installation program starts automatically.
2. Follow the on-screen instructions to install the TWAIN Datasource,
ISIS Driver and the Kodak Scan Validation Tool.
3. Shut down the host computer.
An IEEE-1394 six-pin connector is provided on the rear panel of the
scanner for IEEE-1394 connectivity.
1. Plug the end of the cable with the right angle into the scanner.
2. Connect the other end of the cable into the IEEE-1394 card outlet in
the host computer. Be sure that it is installed correctly and properly
seated.
CAUTION: DO NOT FORCE THE CONNECTOR. If the cable is not
properly connected, it could cause damage to the
scanner.
A-61500 April 2007