Playback; To Video Equipment Without A Dv Jack - Sony DSR-11 Operating Instructions Manual

Playback

To video equipment without a DV jack

22
Chapter 2 Playback and Recording
Recorder
Other VCR
to the audio input
jacks
to the video input jack
to the S-video
input connector
to the LANC jack
Audio cable (not supplied)
Video cable (not supplied)
S-video cable (not supplied)
LANC cable (not supplied)
Connect either an S-video cable or a video cable as the cable for video
signals.
• When you connect the output jacks of the recorder to the input jacks of
this unit, select the input correctly with an input select switch on the
recorder to prevent a humming noise or distortion of the picture.
•Distorted signals (e.g., when played back at a speed other than normal)
will not be recorded properly.
• The LANC connection transmits signals such as control signals, time
code, time counter data, and status data.
• Jacks labeled CONTROL L have the same function as LANC jacks.
Jacks labeled REMOTE may also have the same function.
• Set the LANC switch on the recorder to M. A device which does not have
M / S switch cannot be used to control this unit.
Monitor
Player
DSR-11
Signal flow