Troubleshooting - Kodak i50 User Manual

Troubleshooting

Problem
The light indicates that the scanner is ready,
but the scanner does not respond to the scan
command from the host computer.
The red error light is illuminated or is flashing
after the scanner's power cycle.
The red error light is illuminated while
scanning.
Paper becomes jammed during scanning.
More than one sheet of paper was fed into the
scanner (a multifeed).
Paper becomes skewed in the scanner.
When the scanner is powered up, it makes
noise and does not come to the READY state.
You can specify an image from the scanner,
but the scanner or computer crashes when
scanning.
30
The scanner automatically performs a simple self-test each time it is powered up.
This helps spot major system errors in the scanner itself. When the self-test is initiated,
the READY light flashes. When the self-test is completed, if no error has occurred, the
READY light is steadily illuminated.
Occasionally, you may experience a problem with your scanner. In many cases, you can
easily fix the problem yourself. Refer to the following chart for some common problems
and their solutions.
Verify that the signal cable is firmly seated, then invoke the scan
command again. If there is still no response, reset the scanner by
turning it off, then on again. Reboot the host computer.
Verify that the driver is correctly installed.
The scanner self-test has failed. Reset the scanner by turning it off,
then on again. If the problem persists, contact service.
The scanner has jammed or a multifeed has been detected.
There is a hardware problem. Reset the scanner by turning it off,
then on again. If the problem persists, contact service.
Open the ADF and pull out the jammed paper. Close the ADF.
Flatten document corners and edges. Fan the paper before you load
it in the ADF tray.
Check the feed roller condition. Clean the rollers, if necessary.
Check the feed roller condition. Clean the rollers, if necessary.
Use the paper guides when feeding documents.
The shipping switch was not unlocked from the scanner. Unlock it.
The scanner is not located on a level surface. This may cause the
scanner to function improperly.
Verify that the cable is firmly seated.
Only two SCSI terminators can be connected to the SCSI daisy
chain: one is at the end of the SCSI device and the other is already
in the host adapter.
Solution
A-61182 October 2001