Charcoal Filter - GE JVM3150 Installation Instructions Manual

C4.
MOUNT THE OVEN
3 Attach the oven to the top cabinet by inserting
2 self-aligning screws through outer top cabinet
holes. Turn two full turns on each screw. Be sure
the cord, especially when mounting flush to
bottom of cabinet.
4 Tighten the two screws to the top of the oven
completely. (While tightening screws, hold
the oven in place against the wall and the top
cabinet.)
5 Install grease filters. See the Owner's Manual
packed with the oven.
Installation Instructions
(continued)
22
C5.
WHEN REPLACING THE

CHARCOAL FILTER

If the model is not vented to the outside, the air will be
recirculated through a disposable charcoal filter that
helps remove smoke and odors.
The charcoal filter should be replaced when it is
noticeably dirty or discolored (usually after 6 to
12 months, depending on hood usage). See your
Owner's Manual for the filter kit number.
To replace the charcoal filter:
1 Remove 4 screws on top of grille using a Phillips
screwdriver.
2 Open the door.
3 Remove the grille.
Slide the old filter to the front of the oven and
4
remove it.
Remove plastic and other outer wrapping from the
5
new filter and install the new filter. When properly
installed, the wire mesh of the filter should be visible
from the front.
6 Replace the grille and the 4 screws.
7 Close the door.
Insert mesh-side up
Charcoal
Filter