Table of Contents
Advertisement
3858852
884264
884830
46. Lock the pinion nut with tool 3858852. Press the
shaft down and make sure that the pinion nut engages
in the tool. Fix the tool to the rear bearing housing, us-
ing socket cap screws.
Install tool 884264 or 884830 on the vertical shaft.
Tighten the pinion nut.
Wrench size: 17 mm.
Tightening torque: 110 ± 10 Nm (81.13 ± 7.38 lbf ft).
47. Install the bearing housing on the propeller shaft.
NOTE! Turn the shaft carefully, to avoid damaging the
sealing lips on the seal rings.
Apply sealant, Volvo Penta part no. 1161231-4, to the
mating face between the bearing housing and the
drive.
Then install the propeller shaft and bearing housing on
the gear housing.
Apply thread locking fluid, Volvo Penta part no.
1161231-4, to the screws.
Tightening torque: 30 Nm (22.13 lbf ft).
Repair - lower gear housing, sailboat drive
48. Install the upper nut on the vertical shaft.
NOTE! The chamfered side of the nut must face
downwards.
49. Then screw tool 884753 to the division plane, so
that the "teeth" engage on the nut. Fix the tool, with
the lower gear housing, in a vice.
NOTE! First tighten the nut by hand, so that the tool
lies flush against the division plane.
884753
71
Hide quick links:
Advertisement
Table of Contents
