Windshield Wiper And Washer Switches - Subaru 2015 XV Crosstrek Hybrid Owner's Manual

3-86
Instruments and controls/Wiper and washer
over the windshield or rear window.
. Grease, wax, insects or other mate-
rial on the windshield or the wiper
blade results in jerky wiper operation
and streaking on the glass. If you
cannot remove those streaks after
operating the washer or if the wiper
operation is jerky, clean the outer sur-
face of the windshield or rear window
and the wiper blades using a sponge or
soft cloth with a neutral detergent or
mild-abrasive cleaner. After cleaning,
rinse the window glass and wiper
blades with clean water. The glass is
clean if no beads form on the glass
when you rinse with water.
. If you cannot eliminate the streaking
even after following this procedure,
replace the wiper blades with new
ones. For replacement instructions,
refer to Replacement of wiper blades
11-33.
Windshield wiper and washer
switches
The wiper operates only when the ignition
switch is in the ON or ACC position.
Windshield wipers
: Mist (for a single wipe)
: Off
: Intermittent
: Low speed
: High speed
To turn the wipers on, push the wiper
control lever down.
To turn the wipers off, return the lever to
the position.
For a single wipe of the wipers, push the
lever up. The wipers operate until you
release the lever.
Wiper intermittent time control
When the wiper switch is in the
position, turn the dial to adjust the operat-
ing interval of the wiper. The operating
interval can be adjusted in several steps
from the shortest interval to the longest.