Winnebago Ultimate Advantage Owner's Manual page 49

· If the batteries and fuses are okay, there may
be a failure in the hydraulic system or electri-
cal system. See "Emergency Crank-In In-
structions" below for help.
Front Slideout Room Emergency Crank-In
Procedure (Use only when slideout room will
not retract using control switch)
If a failure occurs in the slideout electrical or
hydraulic systems, and the room will not retract
using the control switch, you can manually crank
the room in using an emergency winch system
described below. The winch is stored in a cargo
compartment on the passenger side of the coach.
Step 1 - Relieve Hydraulic Line Pressure
· Open the hydraulic pump slideout solenoid
valves to release hydraulic line pressure and
let fluid bypass into the fluid reservoir. The
pump is located behind an access panel in the
cargo compartment just to the rear of the LP
Gas Tank on the driver side of the coach. (It
is visible to the rear of this compartment
while the slideout room is extended.)
Slideout Pump Access Panel
inside StoreMore compartment
WARNING
Stop engine, place transmission in
park position and apply parking brake
before lying beneath vehicle for this
procedure.
DRIVING YOUR MOTOR HOME
NOTE: The hydraulic pump is equipped with two
types of hydraulic solenoid valves
shown. The leveling jack solenoids have
a T-handle on the valve shaft that can be
turned by hand. The slideout room sole-
noid has a small 1/4" nut at the end of
the valve shaft that requires you to use a
1/4" nut driver tool that is provided in
your InfoCase.
See the HWH Operator's manual includ-
ed in your InfoCase for specific instruc-
tions on which valves to open for front or
rear slideout rooms and what additional
precautions to follow.
· Open the slideout solenoid valves (with 1/4"
nuts on the ends) on the pump to relieve hy-
draulic line pressure. (See Step 1 under
"slideout Room Emergency Crank-In" on
previous page.) DO NOT LOOSEN NUTS
MORE THAN 3 FULL TURNS.
SECTION 2
2-27