Status
Slide Show does not run
on an external video
device
Picture quality problems
Status
The picture is too dark
or underexposed
The picture is too light
The picture is not clear
www.kodak.com/go/support
Cause
■
Adjust the camera Video Out setting (NTSC or PAL,
■
Make sure the external device settings are correct (see the
device's user's guide).
Cause
■
Use Fill flash
(page
behind the subject.
■
Move so that the distance between you and the subject is within
the effective flash range
■
To automatically set exposure and focus, press the Shutter button
halfway and hold. When the ready light glows green, press the
Shutter button the rest of the way down to take the picture.
■
Decrease the shutter speed or increase the ISO speed
■
Turn the flash off
■
Move so that the distance between you and the subject is within
the effective flash range (see
■
To automatically set exposure and focus, press the Shutter button
halfway and hold. When the ready light glows green, press the
Shutter button the rest of the way down to take the picture.
■
Increase the shutter speed or decrease the ISO speed
■
To automatically set exposure and focus, press the Shutter button
halfway and hold. When the ready light glows green, press the
Shutter button the rest of the way down to take the picture.
■
Clean the lens
(page
■
Make sure the camera is not in Close-up mode if you are more
than 23.7 in. (60 cm) from your subject.
■
Place the camera on a flat, steady surface or use a tripod.
15) or change your position so light is not
(page
15).
(page
15).
page
15).
59).
Troubleshooting
page
28).
(page
13).
(page
13).
52