Miele CVA 6800 Operating And Installation Instructions page 70

Problem solving guide
Message
Fault 73
or
"Check the brew
unit"
Fault 227 to Fault
230,
Fault 233
70
Possible cause and remedy
^ The brew unit cannot be positioned correctly, or it is dirty
and the coffee cannot be processed.
^ Check whether you can remove the brew unit (see
"Cleaning and care – Brew unit").
^ Clean the brew unit if it can be removed (see "Cleaning
and care – Brew unit").
Push the coffee ejector of the brew unit into the correct
position (see diagram).
^ Push the waste container and the water container back in
the machine. Do not insert the brew unit. Close the door
and switch the machine on with the On/Off K sensor.
The brew unit motor will be initialised.
^ When "Insert the brew unit" appears in the display, open
the door and put all the parts back in the machine. Then
close the door.
If the brew unit cannot be removed:
^ Switch the machine off with the On/Off K sensor. Wait for
approx. 2 minutes before switching it back on again.
There is a fault with the automatic spout adjustment.
^ Confirm the message with OK.
Automatic spout adjustment during drink preparation is
deactivated as long as the appliance remains switched on.
You can continue to prepare drinks.