Table of Contents
Advertisement
2-1. INTRODUCTION
2-2. UNPACKING
203
SECTION 2. INSTALLATION
This section provides the installation and operation instructions for
the Henny Penny Heated Holding Cabinet.
Installation of this unit should be performed only by a qualified
service technician.
Do not puncture the skin of the unit with drills or
screws as component damage or electrical shock
could result.
The Henny Penny Heated Holding Cabinet has been inspected,
tested, and packed to ensure arrival in the best possible condition.
The cabinet is packed inside a triple wall carton with sufficient
packing material to withstand normal handling in shipment. The
carton is also strapped onto a wooden base.
Any shipping damages should be noted in the presence of the
delivery agent and signed prior to his or her departure.
To remove the cabinet from its carton:
1. Cut the bands holding the wooden base to the carton.
2. Lift the carton off the cabinet.
3. Remove unit from the wooden base.
4. Remove all packing material from around cabinet and
inside drawers.
5. Remove the top drawer and basket.
6. Remove the water pan by supporting it with one hand and
pulling the latches towards you, with the other hand. The water
pan drops down from the ceiling.
7. Install the four baffles in the slots in the water pan.
8. Reinstall the water pan by aligning the studs in the ceiling with
the holes in the water pan flanges, holding the pan flush against
the ceiling, and pushing the latches towards the rear of the
cabinet. Replace drawer and basket.
9. Peel off protective covering from exterior of cabinet.
Your heated holding cabinet is now ready to be located and
installed.
Model HCH-930/932
2-1
Advertisement
Table of Contents
