Kodak EASYSHARE LS443 User Manual page 90

Camera
Problem
Picture is not
clear.
Slide show does
not run on
external video
device.
Camera freezes
up when a card is
inserted or
removed.
78
Chapter 9
Cause
The lens is dirty.
Subject too close when
taking picture.
Subject or the camera
moved while the
picture was taken.
The subject is too far
away for the flash to be
effective.
Video Out setting is
incorrect.
External device is set
incorrectly.
Camera detects an
error when the card
was inserted or
removed.
Solution
Clean the lens (page
Move so there is at least 2.0 ft (0.6
m) between the camera and the
subject, or at least 0.5 ft (15.2
cm) in Close-up mode.
Hold the camera steady while
taking the picture.
Move so there is no more than
10.8 ft (3.3 m) between the
camera and the subject; 6.2 ft
(1.9 m) in Telephoto.
Adjust the camera Video Out
setting (NTSC or PAL,
page 58).
Refer to the external device's
user's guide.
Turn the camera off, then back
on. Make sure the camera is
turned off before inserting or
removing a card.
96).