Table of Contents
Advertisement
INTRODUCTION
This remote control system was developed to provide a safe, reliable and user-friendly remote control system for gas
heating appliances. This all battery system operates independently of household current. The system operates on radio
frequencies with a non-directional signals. The SYSTEM's operating range is approximately 20 feet. The system operates
on one of 1,048,576 security codes that are programmed into the transmitter at the factory; the remote receiver's code
must be matched to that of the transmitter prior to initial use.
Review COMMUNICATION SAFETY SECTION under TRANSMITTER section and THERMOSTAT SAFETY SECTION
under REMOTE RECEIVER section. These signal/temperature safety features shut down the fireplace system when a
potentially unsafe condition exists.
30259-6-0314
FRBTC REMOTE INSTRUCTIONS
The remote control system offers the user a battery-operated remote control.
The transmitter operates on (2) 1.5V AAA batteries.
It is recommended that ALKALINE batteries always be used for longer battery
life and maximum operational performance.
Before using the transmitter, install the (2) AAA transmitter batteries into the
battery compartment. (Use caution that batteries are installed in the proper
direction)
KEY SETTINGS
•
ON - Operates unit to on position, Manually ON.
•
OFF - Operates unit to off position, Manually OFF.
•
MODE - Changes unit from manual mode to thermostat
mode.
•
SET - Sets temperature in thermostat mode.
1.
2.
3.
4.
5.
6.
DISPLAY
Indicates CURRENT room temperature .
°F OR °C
Indicates degrees Fahrenheit or Celsius.
FLAME
Indicates burner/valve in operation.
ROOM
Indicates remote is in THERMOSTAT operation.
TEMP
Appears during manual operation.
SET
Appears during time the of setting the desired tem-
perature in the thermostat operation.
Page 41
Advertisement
Table of Contents
