Status Light; Power Status Light - Kodak ESP 3200 Series Extended User Manual

Troubleshooting
Problem
Paper jam
Error messages or other
problems you cannot
resolve

Status light

Power status light

Power light
Off
Blinking
On
36
• Check for paper in the rear-access cleanout area.
• Open the printer access door and gently remove any paper from inside the
printer.
• Make sure the paper in the tray is free of tears or creases.
• Make sure you do not overload the paper tray.
For more information, see www.kodak.com/go/itg. Select All-in-one printer,
then Paper jam.
If you need to contact Kodak (see www.kodak.com/go/contact), have the
following information available:
• Kodak Service Number (located inside or on the outside of the printer)
• Printer mode number (located on the back of the printer)
• Computer model, operating system, and version of Home Center Software
• Exact wording of any error message(s)
For more troubleshooting information, go to www.kodak.com/go/esp3250support.
The status light indicates the condition of the printer.
What it means
• The printer is turned off.
– Press the on/off button to turn on power.
• The printer does not have power.
– Make sure that the power cord is plugged into the back of the printer and
into an electrical outlet, and that the electrical outlet has power.
• The printer is busy.
– Wait for the printer to finish the task.
• The printer is ready
www.kodak.com/go/aiosupport
Possible Solutions