Goodman SSZ 16 SEER Technical Manual page 6

HEAT PUMP SPECIFICATIONS
SSZ160601B*
* Up to 24' in equivalent line length
(1)
Wire size should be determined in accordance with National Electrical Codes; extensive wire runs will require larger wire sizes.
(2)
Maximum Overcurrent Protection Device: MUST use Time Delay Fuse or HACR type Circuit Breaker of the same size as noted.
NOTES:
• Always check the serial plate for electrical data on the unit being installed.
• Installer will need to supply 7/8" to 1-1/8" adapters for suction line connections (4 & 5 ton units).
• Installer will need to supply 3/4" to 7/8" adapters for suction line connections (3 ton unit).
• Unit is charged with refrigerant for 15' of 3/8" liquid line. System charge must be adjusted per Installation Instructions Final Charge
Procedure.
• Installation of these units requires the specified TXV Kit to be installed on the indoor coil. THE SPECIFIED TXV IS DETERMINED BY THE
OUTDOOR UNIT, NOT THE INDOOR COIL.
NOTE: This data is provided as a guide, it is important to electrically connect the unit and properly size fuses/circuit breakers
and wires in accordance with all national and/or local electrical codes. Use copper wire only.
Unit specifications are subject to change without notice. ALWAYS refer to the unit's serial plate for the most up-to-date
general and electrical information.
6
Cooling Capacity, BTUH
Compressor
R.L. Amps
L.R. Amps
Low Pressure Switch
Open
Close
High Pressure Switch
Open
Close
Condenser Fan Motor
Horsepower
F.L. Amps
Liquid Line, Inches O.D.*
Suction Line, Inches O.D.*
Refrigerant Charge
Power Supply
Minimum Circuit Ampacity
Maximum Overcurrent Device
Electrical Conduit Size
Power Supply (Inches)
Approximate Shipping Weight
60,000
23.0
118.0
22 PSIG
50 PSIG
610 PSIG
420 PSIG
1.0
3/8"
1-1/8"
273.0
208/230-60-1
(1)
29.8
(2)
1/2 or 3/4
331
60,000
28.8
152.9
22 PSIG
50 PSIG
610 PSIG
420 PSIG
1/6 1/6
1.0
3/8"
1-1/8"
273.0
208/230-60-1
37.2
50 60
1/2 or 3/4
331