Table of Contents
Advertisement
When you have switched to other service, if the
service is provided by a satellite other than cur-
rent one, it will take longer time than usual be-
cause the antenna has to move to the position of
the satellite.
To get the correct position of your desired satellite, perform
the following steps:
1.
Choose your desired satellite at the Satellite Name pa-
rameter.
2.
Set the DiSEqC Command Mode to User.
3.
Select the Goto command at the Motor Control menu.
Then the antenna will turn toward your selected satel-
lite with the position data that the digital receiver has.
4.
If the receiving quality, which is displayed on the right
bottom on the screen, is not good, tune the antenna finely
with the commands of the Movement menu. If you select
the 2(E) movement command, the antenna will move
to the east by two degrees. At this time you had bet-
ter check the receiving quality of every transponder and
choose the best one at the Transponder (or Frequency)
parameter. It will be helpful to your fine tuning.
4.1 Searching broadcasting services
To use DiSEqC 1.2, select the In-
stallation > Motorized DiSEqC
1.2 menu.
At first you have to set the Mo-
torized DiSEqC 1.2 option to
Enable.
23
Advertisement
Table of Contents
