Operating Instructions; Front Panel - Bosch LTC 2810/91 Instruction Manual

LTC 2810/91 | Instruction Manual | Operating Instructions
3.0

OPERATING INSTRUCTIONS

3.1

Front Panel

1. VOLUME Control
Adjust the VOLUME control for the appropriate
audio level.
Turn clockwise to increase sound and
counterclockwise to decrease it.
If the audio input is not used, turn to minimum.
2. CONTRAST Control
Adjust the CONTRAST control for the desired
overall contrast.
Turn clockwise to increase picture contrast and
counterclockwise to decrease it.
3. BRIGHT Control
Adjust the BRIGHT control for the desired overall
picture or display brightness.
Turn clockwise for more brightness and
counterclockwise for less.
4. COLOR Control
Adjust the COLOR control to set the color
(saturation) level.
When turned counterclockwise, the color becomes
pale (low color).
When turned clockwise, the color becomes
saturated (high color).
5. TINT Control (NTSC only; not available in
PAL version)
Adjust the TINT control for the proper color phase
or flesh tone.
When turned counterclockwise, the skin tone
becomes more red in color.
Bosch Security Systems | December 06, 2004
Front Panel
1. VOLUME Control
2. CONTRAST Control
3. BRIGHT Control
4. COLO R Control
5. TINT Control
BOSCH
A/B YC
A R
VOLUME CONTRAST BRIGHT COLOR TINT
B Y
When turned clockwise, the skin tone becomes more green
in color.
NOTE : There is no TINT control in PAL version.
6. POWER Switch
Press the switch to turn the monitor ON.
(The INPUT INDICATOR will illuminate.)
Press the switch again to turn the monitor OFF.
7. Y/C Indicator
The lower green LED will be illuminated when the
Y/C is selected.
8. Y/C Selector
Set the selector to the ON position, when
monitoring a Y/C signal (S-VIDEO, separated Y/C
signal) via the Y/C IN connector on the rear panel.
9. A, B Selector
Set the SELECTOR to A(VIDEO A IN) or
B (VIDEO B IN) for desired BNC input.
A (
) : When monitoring the composite
VIDEO A IN signal (via the VIDEO A
IN BNC connector on the rear panel).
) : When monitoring the composite
B (
VIDEO B IN signal (via the VIDEO B
IN BNC connector on the rear panel).
10. A/B Indicator
The upper green LED will be illuminated when
VIDEO A is selected.
The lower green LED will be illuminated when
VIDEO B is selected.
6
. POWER Switch
7
. Y/C Indicator
8. Y/C Selector
. A,B Selector
9
. A,B Indicator
10
EN | 6