Replacing Lower Oven Temperature Probe - Electrolux EW30GF65G Series Product & Training Manual

Replacing Lower oven temperature Probe

To remove and replace the lower oven temperature
Cover Plate
Photo A
Safety Valve
probe remove the access cover plate that the power
Mounting Screw
cord and strain relief are attached to at the rear of
the range. The cover plate is located to the right of
the safety valve when viewed from behind the range.
(Photo A)
Take out the cover plate mounting screw and remove
Photo B
the cover. The power chord can be disconnected
from the harness connector and placed aside with
the cover plate.
Once the cover plate is removed the lower oven
temperature probe connector can be disconnected
from the harness connector on the right side of the
opening. (Photo B)
Power Cord
Harness Connector
Lower Oven Temp Probe
Harness Connector
Unplug the lower oven temperature probe connector
Photo C
and remove the two screws that mount the probe to
Probe
the rear of the lower oven chassis. (Photo C)
Mounting
The probe can now be pulled out of the chassis.
Screws
Page 45