Electrolux EW30GF65G Series Product & Training Manual page 39

Remove the two screws at the rear corners of the
oven bottom panel. (Photo E)
Lift the rear of the oven bottom up approximately
3 inches and slide the panel toward the rear of the
range to disengage the front edge from the slot in the
front frame. The oven bottom can now be removed.
After taking out the oven bottom remove the
screw at the front end of the bake burner tube and
at the rear in the mounting bracket. (Photo F)
The bake burner assembly with ignitor attached
can now be lifted out of the oven cavity. The
ignitor can now be removed from the bake burner
assembly by removing the two ignitor mounting
screws.
When replacing the bake burner ignitor it is
necessary to remove the burner assembly.
When reinstalling the bake burner assembly make
sure to properly position the end of the tube over
the orifice spud on the gas safety valve. (Photo G)
Burner mounting
screws
Page 39
Photo E
Photo F
Photo G
Burner Tube
Orifice Spud