Lower Oven Components - Wave Touch Models; Replacing Lower Oven Element - Electrolux EW30GF65G Series Product & Training Manual

Wave-touch and iq touch freestanding gas ranges

Hide thumbs

Table Of Contents

Table of Contents

Remove Drawer

1. Before drawer removal, be sure to turn OFF the

lower oven and let the drawer area cool completely.

2. Open the drawer to the fully open position. Using

a phillips-head screwdriver remove the two drawer

screws from the insides of the front oven drawer

compartment (See Fig. 1).

3. With one hand hold the drawer front in place.

Use your other hand to pull the glide away from the

oven (See Fig. 2) until the glide hook

disengages (See Fig. 3 & Fig. 4).

4. Repeat from step 3 above for the other side of

the drawer.

5. With both glide hooks disengaged, carefully

lift the drawer up and away from the oven. Push

both drawer glides into lower oven cavity.

From the rear of the range remove cover plate just

to the right of the regulator by taking out the screw

at the top of the plate. (Photo A)

Lift the plate upward to remove.

With the cover plate removed the wire harness ter-

minal connectors to the lower oven heating

element and lower oven light socket are accessible.

( Photo B)

Unplug the element harness connectors.

With the drawer removed and the element wire

harness disconnected remove the seven screws

that secure the element to the base and remove

the element by pulling forward. ( Photo C )

To remove the mounting screws a short / stubby

¼" nut driver or # 1 square drive screwdriver is

required.

Use caution when working in this area.

There are sharp edges on the element

brackets and other areas. Protective cloth-

ing and / or gloves are recommended.