Electrolux EW30GF65G Series Product & Training Manual page 41

Next remove the oven door and all interior oven
racks. Remove the rack sensor assembly by taking
out the two screws in the top mounting bracket and
lifting the bracket and sensor assembly rod out of the
lower bracket. (Photo A)
Remove the two screws that secure the convection
fan cover to the rear of the oven wall and remove the
cover. (Photo B)
Remove the two screws at the rear corners of the
oven bottom panel. (Photo C)
Lift the rear of the oven bottom up approximately
3 inches and slide the panel toward the rear of the
range to disengage the front edge from the slot in the
front frame. The oven bottom can now be removed.
After taking out the oven bottom remove the
screw at the front end of the bake burner tube and
at the rear in the mounting bracket. (Photo D)
The bake burner assembly with ignitor attached
can now be lifted out of the oven cavity. The
ignitor can now be removed from the bake burner
assembly by removing the two ignitor mounting
screws.
When replacing the bake burner ignitor it is
necessary to remove the burner assembly.
Burner mounting
screws
Page 41
Photo A
Mtg. screws
Photo B
Photo D
Photo C