Door Reversal - Hotpoint FFA52K Operating Instructions Manual

DOOR REVERSAL

GB
It is recommended that you remove any loose items/fittings from inside the appliance and place food into insulated
containers whilst carrying out this operation.
You may require assistance to carefully lay the appliance onto its back onto suitable protective materials (i.e. original
packaging).
1. Lay down the appliance on its back.
2. Unscrew, remove and retain the bottom hinge.
3. Slightly open the bottom door and slide downward remove and carefully place to one side
4. Remove centre hinge and spacer if fitted. Slightly open the top door and slide downwards, remove and carefully
place to one side.
5. Unscrew and remove the top front cover from the cabinet .
6. Unscrew and remove the hinge pin and the bolt from the top right hand and refit them into the hole in the left hand
side. Refit the top front cover.
7. Use a thin blunt instrument
to remove the top and bottom
hinge bushes and blanking
plugs from the doors, take
care not to mark the door
handle. Reposition the
blanking plugs and bushes
on the opposite side.
8. Fit the blanking plugs
provided into the right hand
two centre hinge holes.
1. Slide the top door upwards and locate the top hinge pin into the door brush. Reposition the centre hinge on the
opposite side.
2. Carefully slide bottom door upward
into the centre hinge pin.
3. Unscrew the bottom hinge pin and
refit it on the opposite side..
4. Fit the bottom hinge making sure that
the door is aligned to the cabinet.
5. Carefully stand the appliance upright
in it’s required location and make sure
it is sitting level on the floor. Open and
close the doors checking that the
gasket makes a good seal without any
gaps when the doors are closed.
Note: Replace loose items/fittings back
into the appliance and leave for at least
15 minutes before switching back on.
4
5
6
4
1
7
1
3
2
8
2
3