Door Reversal - Hotpoint RTA 41 Instructions For Installation And Use Manual

Hotpoint refrigerator model rta 41 instructions for installation and use
Table of Contents

Advertisement

DOOR REVERSAL

Warning: Before attempting to remove the doors, switch off the electrical supply and pull out the mains plug.
It is recommended that you remove any loose items/fittings from inside the appliance and place food into insulated containers
whilst carrying out this operation.
You may require assistance to carefully lay the appliance onto its back onto suitable protective materials (i.e. original packaging).
Remove the doors
1. Lay down the appliance on its back.
2. Unscrew, remove and retain the bottom hinge.
3. Slightly open the bottom door and slide downward remove and carefully place to one side
4. Remove centre hinge and spacer if fitted. Slightly open the top door and slide downwards, remove and carefully place to
one side.
5. Unscrew and remove the top front cover from the cabinet .
6. Unscrew and remove the hinge pin and the bolt from the top right hand and refit them into the hole in the left hand side.
Refit the top front cover.
7. Use a thin blunt instrument to
remove the top and bottom
hinge bushes and blanking plugs
from the doors, take care not to
mark the door handle. Reposition
the blanking plugs and bushes on
the opposite side. Fit the blanking
plugs provided into the right
hand two centre hinge holes.
Replacing the doors
1. Slide the top door upwards and locate the top hinge pin into the door brush. Reposition the centre hinge on the opposite
side.
2. Carefully slide bottom door upward into the
centre hinge pin.
3. Unscrew the bottom hinge pin and refit it on
the opposite side..
4. Fit the bottom hinge making sure that the
door is aligned to the cabinet.
5. Carefully stand the appliance upright in it's
required location and make sure it is sitting
level on the floor. Open and close the doors
checking that the gasket makes a good seal
without any gaps when the doors are closed.
Note: Replace loose items/fittings back into the
appliance and leave for at least 15 minutes
before switching back on.
5
6
13
4
1
7
1
4
3
2
2
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents