Jenn-Air JB36NXFXLW00 Technical Education page 32

Install Door Panels
NOTE: First open the door opposite from the one to which you are
installing the door panel.
1. Lower the panel mounting bracket onto the adjustment pins at
the top of the door.
C
A. Door panel
B. Mounting bracket
2. Locate the studs on the back of the door panel. Slide the
studs, top stud first followed by the bottom stud, into the "J"
pockets in the front of the door.
NOTE: It is the washer in the stud, not the head of the stud,
that is inserted in the "J" pocket.
3. Slide the door panel down, into the "J" pocket in the front of
the door.
4. Repeat steps 1 through 3 to install the second door panel.
5. Using slotted hex head screws (provided with refrigerator),
attach the mounting bracket (factory installed), located at the
bottom of the refrigerator and freezer doors, to the respective
door panels. Do not fully tighten the screw.
A
A. Bottom hinge
B. Mounting bracket
Installation Instructions (continued)
C. Adjustment pins
B
Install Top Grille Panel
A
B
Standard Installation - Flush Grille
1. Hook the panel brackets onto the mounting bolts extending
from the top of the refrigerator.
2. Pull the grille panel down slightly to lock into place.
Integrated Installation - Full Height Grille
1. Align the bracket on each side of the top grille panel with the
mounting bolts.
2. Push the grille panel forward until the bracket snaps into
place.
Door Swing Adjustment
It may be necessary to adjust the swing of the door. Make sure the
refrigerator door(s) can open freely. If the door(s) opens too wide,
install the door stop pin (provided with refrigerator).
1. Hold the door open to a position that is less than 90°.
2. Insert the door stop pin into the top hinge in the hole shown.
2-22
B A
A. Top grille panel
B. Cabinet sides
B
A. Panel brackets
B. Grill trim piece
B
A
21