Mounting Procedure - JBL Intellivox-DC115 Installation Manual

Mounting Procedure

The general mounting procedure using the standard
brackets is described below. It is assumed that all necessary
cabling is already prepared with connectors fitted as
described in the previous chapters.
Proceed as follows:
1. Use of the wall plugs and hexagon head screws
supplied is recommended. If using other types, ensure
that the "across-flats" head size does not exceed
11.5 mm (0.45").
2. Mark and drill the holes (8 mm) for the wall plugs. Use
the two holes with the slots running vertically (refer to
Fig 13.1).
3. Insert the plugs and screws into the holes. Tighten the
screws with a spanner, but stop with a few mm of screw
shaft visible between the head and the wall.
4. Check that it is possible to slide a bracket over the
heads.
5. Check that the chosen mounting points will position
the column in the correct vertical angle specified by the
acoustic design (which is usually exactly perpendicular
to the listening area). Use spacers on one or more of
the brackets if necessary.
*If it is intended to connect a PC directly to the Intellivox to carry out the settings file upload (see page 19), leave the
network connector (if any) unplugged and do not replace the connector compartment cover until the upload and
verification procedure has been carried out.
18
6. Using a Philips H2 Screwdriver, attach the brackets to
the Intellivox enclosure with the M5 x 12 pan-head
screws and shakeproof washers supplied. The 10 mm
dia. holes allow screwdriver access to the screw heads.
fig.14 - Bracket attachment
7. Lift the Intellivox and slide the brackets over the heads
of the hex-head screws protruding from the wall.
8. Firmly fasten the screws securing the brackets to the
wall. Re-check the verticality (or other angle if specified)
with a spirit level or similar levelling device.
9. Remove the front grille(s) from the Intellivox by gently
lifting the grille at the locations of the 'snap-on'
fittings which hold it in place. Remove the protective
foam. Unscrew the four self-tapping screws securing
the connector compartment cover and remove the
cover. Thread all cabling through the connector
compartment from the rear so that it is free and
accessible from the front.
10. Terminate and plug in all the connectors (see fig 5.1)
and replace the connector compartment cover and the
grille(s)*.
11. Secure grille(s) at each corner with supplied M4 round
head screws and star retaining washers.
JBL Intellivox Installation Manual
201401/IvxIM_v2.2