Mercedes-Benz C-Class Coupe Operator's Manual page 93

Opening and closing
Overhead control panel
Opens
:
Opens
;
Closes
=
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Press or pull the 3 switch in the corre-
X
sponding direction.
i
If you press the 3 switch beyond the
point of resistance, an automatic opening/
closing process is started in the corre-
sponding direction. You can stop automatic
operation by pressing/pulling the switch
again.
Resetting the sliding sunroof and the
roller sunblind
Reset the sliding sunroof and the roller sun-
blind if the sliding sunroof or the roller sun-
blind does not move smoothly.
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Pull the 3 switch repeatedly to the point
X
of resistance in the direction of arrow =
until the sliding sunroof is fully closed.
Keep the 3 switch pulled for an addi-
X
tional second.
Pull the 3 switch repeatedly to the point
X
of resistance in the direction of arrow =
until the roller sunblind is fully closed.
Keep the 3 switch pulled for an addi-
X
tional second.
Make sure that the sliding sunroof
X
( page 90) and the roller sunblind
Y
( page 91) can be fully opened again.
Y
If this is not the case, repeat the steps
X
above again.
! If the sliding sunroof and the roller sun-
blind cannot be fully closed or reset, con-
tact a qualified specialist workshop.
Problems with the sliding sunroof
Problem: the sunroof cannot be closed
and you cannot see the cause.
G WARNING
If you close the sliding sunroof again immedi-
ately after it has been blocked or reset, the
sliding sunroof closes with increased or max-
imum force. The reversing feature is then not
active. Parts of the body could be trapped in
the closing area in the process. This poses an
increased risk of injury or even fatal injury.
Make sure that no parts of the body are in the
closing area.
If somebody becomes trapped:
release the switch immediately, or
R
during automatic operation, push the
R
switch briefly in any direction
The closing process is stopped.
If the sliding sunroof is obstructed during
closing and reopens again slightly:
Immediately after the sliding sunroof
X
blocks, pull the 3 switch in the over-
head control panel down to the point of
resistance and hold it until the sliding sun-
roof is closed.
The sliding sunroof is closed with increased
force.
If the sliding sunroof is obstructed again dur-
ing closing and then reopens slightly:
Immediately after the sliding sunroof
X
blocks, pull the 3 switch in the over-
head control panel down to the point of
Sliding sunroof
Z
91