Mercedes-Benz C-Class Coupe Operator's Manual page 166

Driving systems
164
Shift the transmission to position P to pre-
X
vent the vehicle from rolling away.
DISTRONIC PLUS is deactivated. The warn-
ing message in the multifunction display
disappears.
The horn will also sound at regular intervals if
DISTRONIC PLUS is activated and you:
switch the engine off, open the driver's
R
door and remove your seat belt.
open the hood.
R
The sounding of the horn alerts you to the fact
that the vehicle has been parked while DIS-
TRONIC PLUS is still activated. The sound
becomes louder if you attempt to lock the
vehicle. The vehicle is not locked until DIS-
TRONIC PLUS is deactivated.
i
If the engine has been switched off, it
cannot be started again until DISTRONIC
PLUS has been deactivated.
If DISTRONIC PLUS is activated and a mal-
function occurs in the system or if there is a
disruption in the voltage supply, the
Immediately Immediately message is shown in the mul-
tifunction display. Depress the brake firmly
immediately until the warning message dis-
appears from the multifunction display or
shift the transmission to position P. DIS-
TRONIC PLUS is then deactivated.
Setting a speed
Press the cruise control lever up : for a
X
higher speed or down ; for a lower speed.
To adjust the set speed in 1 mph incre-
X
ments (1 km/h increments): briefly
press the cruise control lever up : or
down ; to the pressure point.
Every time the cruise control lever is
pressed up : or down ; the last speed
stored is increased or reduced.
To adjust the set speed in 5 mph incre-
X
ments (10 km/h increments): briefly
press the cruise control lever up : or
down ; beyond the pressure point.
Every time the cruise control lever is
pressed up : or down ;, the last speed
stored is increased or reduced.
i DISTRONIC PLUS is not deactivated if you
depress the accelerator pedal. If you accel-
erate to overtake, DISTRONIC PLUS
adjusts the vehicle's speed to the last
speed stored after you have finished over-
taking.
Storing the current speed or calling up a
stored speed
Briefly pull the cruise control lever towards
X
you ?.
Remove your foot from the accelerator
X
pedal.
DISTRONIC PLUS is activated. The first
time it is activated, the current speed is
stored. Otherwise, it sets the vehicle cruise
speed to the previously stored value.
Brake Brake
Setting the specified minimum distance
You can set the specified minimum distance
for DISTRONIC PLUS by varying the time span
between one and two seconds. With this func-
tion, you can set the minimum distance that
DISTRONIC PLUS keeps to the vehicle in
front, dependent on vehicle speed. You can
see this distance in the multifunction display
( page 165).
Y
i
Make sure that you maintain a sufficient
distance to the vehicle in front and comply
with the minimum distance as required by
law. Adjust the distance to the vehicle in
front if necessary.