Electric Powertrain; Gas Powertrain - Bad Boy AMBUSH Owner's Manual

Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
While operating in GAS mode (rear wheel drive) the vehicle can be changed on the fly from 2 wheel rear drive to full
time 4 wheel drive by setting the Mode Switch on the instrument panel to the 4WD (middle) position.
To reduce the possibility of roll-back which could result in severe injury or vehicle damage, do not
release service brake until engine has started.

Electric Powertrain

To operate the vehicle in electric only mode:
•
Set the Mode Switch (2) to ELEC.
•
Place the key in the key switch and turn it to the ON/N posi-
tion. The green LED above the N and the LED above the left
corner of the Mode Switch should be lit unless the light
switch has been set to BLACKOUT.
•
Turn the key to the desired direction; F for forward or R for
reverse. The green LED above the direction letter should be
lit to indicate the vehicle is ready to drive unless the light
switch has been set to BLACKOUT.
•
Press the brake pedal and hold it down.
•
Release the parking brake.
•
Slowly press the accelerator pedal to start the electric motor
while releasing pressure on the brake pedal.
•
When the accelerator pedal is released the motor will stop
and the vehicle will slow down and eventually stop. To stop
the vehicle more quickly, press the brake pedal.

Gas Powertrain

To operate the vehicle in gas engine only mode:
•
Set the Mode Switch (2) to GAS. Use of the choke may be required if the engine is cold, see Cold Starting.
•
Place the key in the key switch and turn it to the ON/N position. The green LED above the N and the LED
above the left corner of the Mode Switch should be lit unless the light switch has been set to BLACKOUT
•
Press the brake pedal and hold it down.
•
Release the parking brake.
•
Turn the key to the desired direction; F for forward or R for reverse. The green LED above the direction letter
should be lit to indicate the vehicle is ready to drive unless the light switch has been set to BLACKOUT.
•
Release the parking brake.
•
Slowly press the accelerator pedal to start the gas engine while releasing the pressure on the brake pedal.
•
When the accelerator pedal is released the engine will stop and the vehicle will slow down and eventually stop.
To stop the vehicle more quickly, press the brake pedal.
OPERATION
ELEC
4WD
GAS
Page 4 - 9
4