Load Bed Configurations And Capacities; Manual Lift Bed; Manual Bed Latch; Electric Lift Bed Operation - Bad Boy HD G Owner's Manual

OPERATION AND SERVICE INFORMATION
Read all of manual to become familiar with vehicle. Pay attention to all NOTICES, CAUTIONS, WARNINGS and DANGERS.
Always place a gas can on the ground before filling.
Never fill a gas can in the bed of the vehicle. Static elec-
tricity is built up during the fueling process and could
discharge causing the gasoline vapor to ignite.
Fig. 14 Load Bed Configurations and Capacities

MANUAL LIFT BED

Exercise caution while operating the manual
lift bed to ensure the bed is not released dur-
ing lifting or lowering procedure. Severe injury
could result if bed is released and traps fingers
or other body parts.
To lift the manual lift bed, pull back on the latch release
handle immediately behind the driver seat. Raise the
bed using the handle on the side of the bed.
Front of Vehicle
Fig. 15 Manual Bed Latch
Page 8
CONVERTIBLE CARRIER
(Rear Facing Seat/Cargo Deck)
2 Persons. or Cargo not to
exceed 250 Lbs (113 kg)
Maximum Vehicle Capacity
800 lbs. (360 kg)
ROTOMOLDED BED
with Manual Dump
or Optional Electric Dump
Maximum Bed Capacity
500 lbs. (225 kg)
Maximum Vehicle Capacity
800 lbs. (360 kg)
Manual Load Bed Latch
Move Rearward to release

ELECTRIC LIFT BED OPERATION

Exercise caution while operating the electric
lift bed to ensure clothing is not caught during
lifting or lowering procedure. Severe injury
could result if bed is lowered and traps fingers
or other body parts.
The electric lift switch is
located on the driver side of
the front seat panel. Move the
toggle switch lever up to raise
the load bed and down to
lower.
Before operating load bed,
check to ensure no one is
behind the vehicle.

TAIL GATE OPERATION

To open the tail gate, lift tail gate straight up with a
sharp upward pull to lift out of the closed position and
pivot out for open position. To remove the tail gate,
remove the side cables from the load bed and open tail
gate until it is straight down, move tail gate panel
straight up to remove from pins and remove from the
load bed. Reassemble in reverse order.

SEATING

VEHICLES EQUIPPED WITH CONVERTIBLE
CARRIER
To prevent severe injury or death, rear seat
passengers should hold on to both the hip
restraints and the rear hand hold when the
vehicle is in motion. Always be sure that all
passengers are seated and holding on before
operating vehicle.
Be sure that all passengers are seated and holding onto
both the hip restraint and the rear hand hold (rear facing
passengers) before operating vehicle.
Fig. 16 Electric Lift Switch